adTempus 4.1 crashed when setting trigger properties

James Liu (3 posts)
June 19, 2014 02:12 PM
Accepted Answer

Installed the new version of adTempus, 4.1.0. After created a shared schedule and use it in an new job, in trigger property, reset the start date, click 'Cancel',  crash happened.

 

Another issue is,  when save the shared schedule without name it, the database error message popup and a detail error can be found in Event Viewer. 

See screenshot attached.

-James

Attachments

Bill Staff (604 posts)
June 20, 2014 08:35 AM
Accepted Answer
I was not able to reproduce either problem based on the information you gave, so I'm obviously not doing it the same way you did.  If you are able to make the errors happen again, please describe the exact steps that you took.
James Liu (3 posts)
June 20, 2014 09:04 AM
Accepted Answer

OK, I can reproduce it without doubt. Please do this steps:

1. create a shared schedule: like weekdays

2. create an new job using this shared schedule. save it.

3. Edit this job schedule.  Change day selection as my screen shot. check "This selection only applies until", set it to a future day. 

4. Click "cancel" 

I hope it helps.

 

Attachments

James Liu (3 posts)
June 20, 2014 09:18 AM
Accepted Answer

another strange thing is: after uncheck "using shared schedule", and check "enable this schedule" on top, the start date will be reset from "Jun 20" (today) to Jun 19. 

That's where the "Jun 19" in above crash message coming from.

Please correct me if this is a intend behavior. Thanks.

James

Attachments

Bill Staff (604 posts)
June 25, 2014 08:48 AM
Accepted Answer
I was still not able to reproduce the error you got. Does it happen every time for you?

Replies are disabled for this topic.